These settings indicate the recommended times to wash parts printed in Formlabs resins using Form Wash. Program the wash time by using the display and knob on Form Wash. Wash times may vary slightly, depending on the size of parts, concentration of resin in IPA, and IPA circulation.
|Tough V4||20 minutes||Tackiness has been observed on part surfaces when washed in alcohol with more than 5% resin concentration.|
|Castable V2||10 minutes||Wash Castable parts for the shortest time necessary to remove liquid resin. Allow all IPA to fully evaporate from the parts before curing and casting.|
|All other resins||10 minutes||Tackiness has been observed on part surfaces when washed in alcohol with more than 10% resin concentration.|
Two factors work together to remove the thin layer of liquid resin from the surface of printed parts: solvation and agitation. Learn more about the factors that lead to the cleanest part surfaces.
TIP:Use separate wash buckets to preserve part color and quality. Maintain separate equipment to meet biocompatibility requirements.
When to Change the Wash Time
For a wash bucket with highly resin-concentrated IPA, add an additional 5 minutes to the Wash Time. Testing at Formlabs indicates that parts may start to feel tacky when coming out of an IPA solution that is 5-10% concentrated with resin. When properly calibrated in fresh IPA, the hydrometer included with Form Wash recommends replacing IPA at around 10-12% resin concentration. Depending on the sequence, part size, and volume of solvent, up to 200 parts can be washed before emptying and fully replacing IPA.
The lifetime of the IPA bath, or the amount of use before the alcohol needs to be replaced, can be prolonged with a revised workflow. Consider rinsing parts with a small volume of alcohol before inserting printed parts in Form Wash. The preliminary rinse option will remove the majority of resin and keep the alcohol in the Form Wash bucket cleaner.