After printing, use the tools included in the Finish Kit to remove and rinse each part, remove supports, and bring the print to completion.
Included in the Kit
1. Rinse Station
Holds the rinse buckets, and has ﬂip lids for easy one-handed operation.
2. Rinse Buckets
Two large buckets to be partially ﬁlled with isopropyl alcohol (IPA).
3. Rinse Basket
Transfer parts from one bucket to the next with one hand. The basket can rest on the edge of the rinse bucket to allow your parts to drip.
4. Rinse Bottle
Keep fresh IPA for rinsing prints and cleaning internal channels.
5. Finishing Tray
Provides a catch-all workspace for resin or IPA drips, and a place to rest sticky parts and tools.
Use to carefully remove unwanted cured material from the resin tank.
Can be used to remove parts from the build platform as well as carefully cleaning and inspecting the resin tank for cured material.
8. Removal Tool
Use under the “quick release tabs” generated by PreForm to release the base of your parts from the build platform.
Provides a place to secure the build platform as you work on removing your print. See the reverse side for more instructions on using the jig.
10. Flush Cutters
Use to carefully remove support tips from your prints.
11. Disposable Nitrile Gloves
Wear gloves when removing and ﬁnishing your prints.
Using the Jig
Attaching the Build Platform to the Jig
With your print facing upwards, push the build platform onto the jig until it sits secure.
Orientations of the Build Platform Jig
Use the jig as a place to rest the build platform. For parts that are difficult to remove, you can hold the jig at an angle and apply more force.
Printer Maintenance Tools
Use to remove fingerprints or smudges from the underside of your resin tank. Do not use on first surface mirrors inside your printer.
PEC*PAD Contaminant Free Wipes
Use to clean the delicate optical mirrors, only when instructed by Formlabs Support. Attempting to clean your mirrors without guidance or using other products may permanently damage your mirrors and void your warranty.
You will also need:
90%+ Isopropyl Alcohol (IPA). IPA works as a solvent to remove leftover uncured resin from your print. Learn more.
Paper Towels. Great for catching resin drips and wiping down surfaces.