Before submitting a support request for failed prints on the Form 2, please perform these initial troubleshooting steps to help us process your request as quickly as possible.
As you go through these steps, note your results and include them in your next message to Support.
TIPCheck the expiration date of your resin. If it is close to a year old, you should replace your resin before trying any of the following steps.
1. Clean the Resin Tank
Whether a tank is new or has already been used, an optically clear path for the laser beam is essential for printing. Before confirming a print, inspect the resin tank for markings or cured resin particles.
Pull the scraper from back to front
TIPPull the scraper toward the front of the printer at a shallow angle. Take care not to push resin over the sides of the tank’s walls.
Filter the resin to remove debris
Use a filter to remove debris, fine particles, and other contamination in the resin.
If you see or feel any resin cured in your tank, it's essential to remove it by cleaning the tank or the next print will fail.
When you’re finished, the tank’s bottom window should be optically transparent. If you see any damage or ghosting along the bottom of the tank, it may be that the tank needs replacing. If you've used more than 1000 mL of resin in your tank's life, there might not be visible damage, but your tank could still be negatively affecting your prints. If you see smudging or fingerprints on the optical window of your resin tank, you should empty out the resin and clean the underside of the tank.
2. Check the Optical Window
Use Formlabs instructions to inspect the optical window for dust, fingerprints, or contamination. If you see any dust or contamination on the optical window, please use Formlabs instructions to clean the optical window.
3. Run the Test Print
In order to introduce a known good variable to isolate any printing issues, you can run a Formlabs test print.
First, make sure your firmware and software are upgraded to the latest version. Print our test print file (available for Clear, Grey, White, and Black Resins) with the material settings set to Clear/Grey/White/Black (whichever you’re using) at 100 microns. Please re-generate the supports using all of the default values. Changes to these settings prevent us from establishing a good baseline.
4. Photograph the Test Print
Make sure to take clear, focused photographs of your test print so Customer Support can best diagnose your issue. It is most helpful to see the following angles of your test print, both on the build platform and then fully dried and finished:
After you have finished all of the troubleshooting steps, please submit the photos of your test print within a new (or current) support request, along with the serial name and original order number of your machine. If you have already submitted a request and opened a conversation, please include these additional photos while you wait for a response from our support team. You can also include photos of any print failures in the same focused, well-lit style of the test print photos.
TIPFor a Form 2 issue, before or immediately after contacting support, navigate to the printer's Settings menu, then select Printer Info and Upload Diagnostic Info.
We will get back to you within 24 hours (Monday-Friday) of receiving your message and information. Including the above information in your request will help us diagnose your issue and get you back up and printing as quickly as possible!